Precautions, Warnings for use, Warning for power supply cord – Sharp CV-P10NC User Manual

Page 6

Advertising
background image

PRECAUTIONS

Points to keep in mind when using your air conditioner.

WARNINGS FOR USE

• Install the air conditioner in accordance with the installation instructions in the lat-

ter section of this manual.

• Do not modify any part of this product.

• Do not insert anything into any part of the unit.

• Ensure the power supply used has an appropriate voltage rating.
Only use a three-pin grounded electrical AC socket rated 125V, 60Hz,

and 15 amps or more as shown on the right.

Use of a power supply with an improper voltage rating can result in

damage to the unit and possibly fi re.

• Always use a fuse with the proper amp rating.
Do not, under any circumstances, use wire, pins or other objects in place of a proper

fuse.

• In the event of any abnormality with the air conditioner (ex. a burning smell), turn it

off immediately and disconnect the power supply.

WARNING FOR POWER SUPPLY CORD

• This air conditioner uses a plug with a built-in fuse.
Read the precautions on the plug before using the air conditioner.

• Always conduct a “Power Plug Check” (See Page 16) before use to confi rm the

power plug functions normally.

• This power plug must only be plugged into an appropriate wall socket. Do not use

in conjunction with any extension cords.

• Push the power plug securely into the socket and make sure it is not loose.

• Do not pull, deform, or modify the power supply cord, or immerse it in water.
Pulling or misuse of the power supply cord can result in damage to the unit and cause

electrical shock.

• A damaged power supply cord must be replaced with a new power supply cord

obtained from the product manufacturer and not repaired. Replacement must be
performed by manufacture's service agent in order to avoid a hazard.

NOTE

Radio or TV Interference

If this room air conditioner should cause interference to radio or television reception, try to
correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the room air conditioner and radio/TV receiver.
• Connect the room air conditioner into an outlet on a circuit different from that to which the

radio/TV receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

E-4

Advertising