Sony 170S7 - Manual

Quick-Use Guide
Cable Box with RF In/Out Jacks
This connection will not supply Stereo sound to the LCD TV Monitor. The sound from the Cable
Box will be monaural (single-channel, not left and right).
1 Connect the Cable TV signal to the IN jack (or RF IN or CABLE IN) on the Cable
Box.
2 Connect an RF coaxial cable (not supplied) to the OUT jack (or TO TV or RF OUT)
of the Cable Box.
3 Connect the other end of the coaxial cable to the TV jack on the LCD TV Monitor.
Screw it down finger tight.
4 Set the Channel 3/4 (or Output channel) switch of the Cable Box to 3 or 4. Set the TV to
the same channel. When watching TV programming, change channels at the Cable Box,
not the LCD TV Monitor.
TO TV CABLE
IN
3
1 2
OUTPUT
CH
3 4
DC IN ANALOG AUDIO OUT
TV
S-VIDEO
VIDEO
AUDIO
1 2
TV
There are several ways to connect your new LCD TV Monitor to your other
equipment. This Quick-Use Guide shows the easiest most common connection.
Cable TV signal from
the Cable Company
75Ω
Coaxial
Cable
75Ω jack on rear
of Television
NOTE: To see how to make other connections, please refer to the Owner’s
Manual.