Introduction, Electric tacker pet 23 vario, Proper use – Kompernass PET 23 VARIO User Manual
Page 4: Features and equipment, Included items
6 GB
Introduction
Electric tacker PET 23 VARIO
Q
Introduction
Please make sure you familiarise yourself
fully with the way the device works before
you use it for the first time and that you
understand how to handle electrical power tools cor-
rectly. Further details can be found in the operating
instructions. Keep these instructions in a safe place.
If you pass the device on to anyone else, please
ensure that you also pass on all the documentation.
Q
Proper use
The electric tacker is suitable for domestic use only
and is intended exclusively for stapling cardboard,
insulation, leather, cloth (textile or natural fibres) or
similar materials on to hardwood, softwood, chip-
board or similar plywood-type materials.
The device is suitable for use in dry rooms only. Any
improper use gives rise to serious danger of accident
and invalidates the guarantee.
Q
Features and equipment
1
Hand grip
2
Trigger
3
Front plate
4
nose
5
Magazine
6
Impact force controller
7
Magazine slider
8
on / oFF switch
9
Mains lead
10
Hexagonal socket screw key
Q
Included items
1 Electric tacker PET 23 Vario
150 no. fine wire staples 12 mm: Type 53
150 no. fine wire staples 18 mm: Type 53
150 no. narrow-backed staples 19 mm: Type 55
150 no. nails 23 mm: Type 47
1 Hexagonal socket screw key
1 operating instructions
1 Booklet “Guarantee and service”
The following pictograms are used in these operating instructions / on the device:
Read instruction manual!
Wear hearing protection, dust
protection mask, protective glasses
and protective gloves.
observe caution and safety notes!
Keep children away from electrical
power tools!
Caution – electric shock!
Danger to life!
Protect electrical power tools from
moisture!
Explosive material!
Check that the device, mains lead
and plug are in good condition!
Safety class II
Dispose packaging and appliance in
an environmentally-friendly way!
V~
Voltage
PET23_ELECTRIC STAPLE GUN_Content_LB4.indd 6
25.04.2008 9:19:15 Uhr