Kenwood D-S300 - Manual (Page 20)

D-S300 (En)
2 0
The following procedure allows to record a CD within the specified tape length so that no music is interrupted in the middle
at the ends of sides A and B.
Editing
1
Light the “EDIT” indicator.
: Keys and control used in the operations described on this page.
D E T I C ? - ?
MULTIPLE CD PLAYER D-S300
2
Enter the recording time of the tape.
When using the TIME key:
TIME
2 Set the entry.
When using the numeric keys:
+10
5 4 3 2 1
0 9 8 7 6
Go to step
2
within 8 seconds.
If more than 8 seconds have elapsed,
press the key again.
Mode
Edit
ENTER
ENTER
EDIT MODE
1 2 3
4 5 6
7 8 9
0 +10
ENTER
Time
ENTER
EDIT MODE
1 Select the time.
Blinks. Do this operation in the stop mode.
RC operation Press the numeric keys as shown below.
30-minute tape : 000)
46-minute tape : 00006
GRC operation Press the ENTER key after selecting each nu-
meric icon.
30-minute tape : 0ENTER, 0ENTER,
0ENTER, )ENTER
GRC operation RC operation
GRC operation RC operation
÷ Recording within 99 minutes can be specified in minutes (2 digits).
÷
If you commit a mistake in time entry, press the P.MODE key and
restart the procedure from the beginning.
÷
By pressing the TIME key the set time-length intervals will change in
this order:
÷ The interval length can be adjusted with the skip keys 4 and ¢ in
units of one minute (to a maximum of 99 minutes).
" 46 =54=60=74=90= ?? "
=
D E T I C 4 - 6
÷ Load a disc in the CD player.
÷ Check that the unit is in the normal play
TRACK mode.
#
÷
Set the INPUT SELECTOR to ”CD“ on the
connected device such as AV CONTROL
CENTER or receiver.
Preparation
GRC operation : Complete the procedure in “Basic Operations
for the Graphical Remote Control Unit (GRC)”
90
ENTER
E d i t