Konexx MOBILE KONNECTOR - Manual (Page 11)

through your Mobile Konnector
Receiving a data file
When someone calls you to send a data file, use the following procedure to answer the call and receive the file.
1. If you will be using your communication software's manual answer or manual receive command to answer the call, skip to
step 2.
Otherwise, place your modem into direct connect (local terminal) mode. The manual that came with your communication
software should explain this procedure.
2. When the telephone rings, lift the telephone handset from the cradle. Leave the handset out of the cradle. DO NOT hang it
up, or you will terminate the call.
3. Use your communication software's manual answer or manual receive command to answer the call.
OR
From direct connect mode, type ATA and press
Enter to have your modem answer the call.
4. At the end of the data transfer, return the handset to the cradle.
5. To hang up, use your communication software's call-termination feature, or type ATH0 and press Enter from direct connect
mode.
! The telephone handset is electronically disconnected when the modem goes off-hook. You must hang up your modem to
restore use of your telephone handset.
Receiving a fax document
When someone calls you to send a fax document, use the following procedure to answer the call and receive the document.
1. When the telephone rings, lift the telephone handset from the cradle. Leave the handset out of the cradle. DO NOT hang it
up, or you will terminate the call.
2. To use a fax/modem, use your fax software's manual answer or manual receive command to answer the call.
OR
To use a fax machine, press its Start button on the fax machine.
3. After you receive the document, return the handset to the cradle.
4. To hang up a fax/modem, use your fax software's call-termination feature.
OR
To hang up a fax machine, press its Stop button.
Operating tips
T
o ensure you get the most out of your Mobile Konnector, observe the operating tips in this chapter.
Powering the Mobile Konnector
Your Mobile Konnector must have batteries or the AC adapter to operate in Data Mode.
♦
Use only the AC adapter supplied with your Mobile Konnector. Do not use an adapter for a different device.