Kambrook CORDFREE KSK110 - Manual (Page 6)


CARE AND CLEANING
Always switch off at the power outlet, and then
unplug the appliance from the power outlet before
cleaning.
CLEANING THE KETTLE ExTERIOR
The outside stainless steel surface of the kettle
may be wiped over with a damp cloth and polished
with a soft, clean dry cloth.
Note: Do not use chemical, steel wool, or abrasive
cleaners to clean the inside or outside of the kettle.
 Caution: to prevent damage to the applianCe do
not use alkaline Cleaning agents when Cleaning, use
a soft Cloth and mild detergents.
 warning: never immerse the kettle base, switCh
area, power base or power supply Cord in water, or
allow moisture to Come in ContaCt with these parts.
CLEANING THE REMOvABLE FILTER
The Kambrook Stainless Steel 1.8L Kettle features
a removable mesh filter to filter out scale deposits
for cleaner water. To remove the scale deposits,
remove the filter by opening the lid of the kettle.
Pull the filter firmly to remove.
The filter can be cleaned by running under hot
water and rubbing with a soft cleaning cloth or
brush. To replace the filter, simply press the filter
down firmly into the slot behind the spout of
the kettle.
TIP: The filter could become damaged with time,
please check regularly and replace if found
damaged.
Note: Ensure the kettle and water have cooled
down before attempting to clean the filter.
MINERAL DEPOSITS AND
DISCOLOURATION
Due to the large surface area of the concealed
element interior base, discolouration due to mineral
deposits from tap water may appear more obvious by
leaving a brown stain on the base. THIS IS NOT RUST.
To remove the discolouration, follow the
instructions “Removing mineral deposits”.
REMOvING MINERAL DEPOSITS
Mineral deposits in tap water may cause the kettle
interior and water window to discolour over time. This
may be removed by using a proprietary kettle descaler
which is available from most leading supermarkets,
department stores and hardware stores.
ALTERNATIvELY
Fill the kettle until 2 ⁄
3
full with 1 part vinegar (or
a few slices of lemon) and 2 parts water, bring
to the boil and allow to stand overnight.
Empty the solution from the kettle. Fill the kettle
with clean water, bring to boil and discard the
water. Repeat and the kettle will be ready
for use.
STORAGE
Ensure the kettle is switched off, cleaned and
dried before storing. Ensure that the lid is closed
and locked firmly into place. Wrap the power cord
around the cord storage under the power base.
Stand the kettle upright on the power base. Do not
store anything on top.
1.
2.
KSK110_KETTLE_IB_FA.indd 6 20/5/09 1:49:05 PM