LG AR702TS - Manual (Page 22)

22
Speaker System Connection
For the best surround sound, you should connect 6 speakers and/or a powered subwoofer.
Connect the your front, center, surround, surround center speakers, and subwoofer by using the speaker wires.
Using a suitable cable, connect the SW (PRE OUT) to an input on optional powered subwoofer, as shown below.
Notes
• Turn the unit off before connecting the speakers wires.
• Be sure to match the speaker wire to the appropriate terminal on the components: + to + and – to –.
If the cables are reversed, the sound will be distorted and will lack bass.
• Be sure to use speakers with the specified impedance as shown on the rear panel of this unit.
• Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shock.
• AR702NS model does not supply the speakers. If necessary, be sure to use speakers with the specified
impedance as shown on the rear panel of the unit.
Connecting speaker wire
1. Loosen the knob by turning it counterclockwise.
2. Insert the bare part of the wire into the hole in side of each terminal.
3. Tighten the knob by turning it clockwise to secure the wire.
+
-
Front speaker (L)
Active subwoofer
Front speaker (R)
Surround center
speaker
Surround
speaker (L)
Surround
speaker (R)
Center speaker
LINE INPUT
Black Red Black Red Black Red
Black Red Black Red Black Red
1. 2. 3.