Lucent Technologies 9077 16S - Manual (Page 143)

SP Switch Router Adapter Guide - 1.4 Update 2 Index-1
Index
520MB spinning disk, configuring , 2-6
9076, 9077
9077 installation overview , 2-5
9077 support on SP web page , D-1
system names , 1-3
what these refer to , 1-3
A
AC power supplies , 1-4
active connections, netstat -an , 3-10
Admin Status (MIB parameter) , 2-34
administrative network
router’s Ethernet cable , 1-4
topology diagram , 1-2
alias address, in grifconfig.conf , 2-21
argument field, in grifconfig.conf , 2-23
ARP
as used in SP Switch networks , C-2 , C-3 ,
C-5
ARP mismatch
switch route not found , 3-21
ARP table
grarp command , 3-3
how to flush , 3-20
maint display command , 3-20
attaching cables , 2-10
procedures , 2-11
autojoin option , 2-40
B
bad packets from switch , 3-23
binaries, specify different , 2-24
boot and reset LED activity , 1-9
boot errors, indicated by LEDs , 1-9
boot messages, gr.boot log file , 3-32
BOOT-REQUESTED, state of , 2-37
bridging
collect data via grdinfo , 3-26
broadcast address, in grifconfig.conf , 2-22
C
cables
attaching to SP Switch Router Adapter
card , 2-10
factory-shipped components , 1-3
from SP Switch Router to Ethernet hub ,
2-10
SP control workstation-to-SP Switch
Router , 1-4
attaching , 2-10
SP Switch cable connector end , 1-6
SP Switch-to-SP Switch Router , 1-3
attaching , 2-10
to Ethernet hub from SP Switch Router ,
2-10
card profile
change default dump settings , 2-25
ICMP settings , 2-24
individual card configuration , 2-24
specify different run-time code , 2-25
communications bus traffic, UDP , 3-19
community names, and spenmgmt , 1-17
configuration
assumptions , 2-3
installing configuration files , 2-35
SNMP procedure , 2-18
configuration examples
multiple SP partition, multiple cards , C-6
recovery at card failure , C-5
single SP partition, multiple cards , C-3
single SP partition, single card , C-2
configuration files
for SP Switch Router Adapter card , 2-16
configuration parameters
installing on card , 1-18
Configuration State (MIB parameter), list of
states , 2-34
configuration via SNMP , 1-15
configuration, network
examples, see Appendix C
CONFIGURING, state of , 2-37
connection options , 1-3
connection status, netstat -an , 3-10