LG D5966W - Manual (Page 20)

Your dryer features FlowSense ™ , an innovative
sensor system that automatically detects
blockages and restrictions in dryer ductwork.
Keeping ductwork clean of lint build-up and free
of restrictions allows clothes to dry faster, reduces
energy use, and helps prevent fi res.
When the dryer is fi rst installed, the duct condition
test must be performed. This alerts you to any
existing problems before the dryer is used. The
dryer also saves this information to compare and
measure future changes.
To activate the duct condition test cycle:
Press and hold the DAMP DRY BEEP and
TEMP CONTROL buttons at the same time.
While holding these buttons, press POWER
ON/OFF.
The dryer will show lnS in the number display
to indicate that it is in duct condition testing
mode.
Press START/PAUSE. The dryer will run for
approximately 2 minutes to test
for blockages or restrictions to air
fl ow in the ductwork.
DUCT CONDITION TESTING
I N S TA L L AT I O N I N S T RU C T I O N S I N S TA L L AT I O N I N S T RU C T I O N S
If no bars are shown in the display,
the ductwork is free from blockages or
restrictions.
If all bars are lit, the dryer ductwork
has a blockage that needs to be
removed immediately.
Correct Venting
1
2
3
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows
or bends.
Check for blockages and lint buildup.
Make sure the ductwork is not crushed
or restricted.
20