LifeSource UB-328 - Manual (Page 11)

ABOUT MEMORY
The UB-328 automatically stores up to 30 blood pressure and pulse
measurements in its memory. Measurements stored in memory are assigned an
index number in the order of the newest to the oldest. The oldest reading displays
as "n01". The M symbol in lower left corner of the display screen indicates that
you are viewing a previous measurement stored in memory.
To retrieve readings, follow these simple steps:
1.
When the display screen is blank, press and release the
Memory button. You will see the average blood pressure
reading displayed. Press and release the Memory button
again. You will see the index number of the most recent
reading followed by the measurement.
2.
If you want to retrieve other measurements in memory,
press and release the Memory button repeatedly until the
desired index number is reached (e.g. n03). The
measurement will then be displayed.
3.
The display will shut off automatically a few seconds after
the readings are displayed.
To clear the measurement history from memory, remove the
batteries from the unit and then place the batteries back into the
battery holder.
NOTE: If there are no measurements stored in memory,
you will see 0s displayed vertically followed by a blinking "A00".
NOTE: Stored measurements will be lost if batteries become low or are
removed.
E-8 LifeSource Health Line (Toll-Free): 1-888-726-9966