Panduit Cougar LS9 - Manual (Page 35)

LABELING EXERCISES
35
ƒ Enter start, end, and increment values
ƒ Scroll down or up to Place On…
ƒ Select Place On… Labels (this allows more than 9
terminals in a serialization
• Step 6: Press Print
o If you see the Tools too big error, then reduce the font size,
increase terminal space, or check the label rotation.
Exercise 7
Create DIN terminal block labels
NOTE: DIN terminal block labeling is based on European standards and
is primarily used in European countries. The unit of measure for
length in DIN Mode is millimeters (mm).
• Step 1: Insert a continuous tape cassette, such as T050X000VPC-BK
• Step 2: When prompted, select New Blank File. Save previous label if
necessary.
• Step 3: Press F5 to begin the DIN Mode function.
• Step 4: Enter the Module Size
• Step 5: Enter the Module Span
• Step 6: Create label text or tools
• Step
7: Press Print
• Step 8: Repeat steps 4 through 6 until print job is complete
• Step 9: Press DEL at steps 4 or 5 to exit DIN Mode
Hint: You can separate the terminal legends with
lines across the label. To do this, press the
Line key, select @ Pages – Yes. Press Enter.
You can change the terminal spacing by:
• Pressing the Shift + DEL keys, to
Clear All Pages & Format. Then enter
a new terminal space and press the Enter
key.
• …Or by using the LENGTH function.