Petsafe PIF-275-19 - Manual (Page 15)

www.petsafe.net 15
5. Check the tightness of the Receiver
Collar by inserting one finger
between the end of a Contact Point
and your pet’s neck. The fit should be
snug but not constricting (G).
6. Allow your pet to wear the collar for
several minutes then recheck the
fit. Check the fit again as your pet
becomes more comfortable with the
Receiver Collar.
7. Trim the collar as follows (H):
a. Mark the desired length of the
Receiver Collar with a pen. Allow
G
H
for growth if your pet is young or grows a thick winter coat.
b. Remove the Receiver Collar from your pet and cut off
the excess.
c. Before placing the Receiver Collar back onto your pet,
seal the edge of the cut collar by applying a flame along
the frayed edge.
8. Put battery in Receiver Collar.