Polaris 800 Assault RMK - Manual (Page 109)

105
MAINTENANCE
Steering System
n
Ski Skags
WARNING! Worn skis and/or skags will adversely affect handling. Loss of
vehicle control may result, causing serious injury or death. See your dealer's
studding chart for recommended skags. If you install longer or more aggressive
carbide skags than the original equipment, it may also be necessary to add track
studs to maintain proper vehicle control while turning on hard-packed snow or
ice.
Check skags before each use of the snowmobile to ensure positive steer-
ing characteristics. Skags must be replaced when worn to half their orig-
inal diameter. Carbide skags must be replaced if any abnormal wear or
chipping is found.
Skag Replacement
Some models are equipped with single skags. Other models are
equipped with dual skags.
1. Raise and support the front of
the snowmobile so the skis
are approximately 6" (15 cm)
from the ground.
2. Remove the attaching nuts
and pry the skag downward.
3. Remove the front end of the
skag.
4. Remove the rear end of the
skag.
5. Reverse the steps to install a
skag.
Skag