Set up library menu selections – Plasmon LIBRARIES D2175 User Manual
Page 50
Menu System
Plasmon D875 - D2175 User Manual
Page 48
Document Revision E
Table 9. Set Up Library Menu Selections
Menu Selection
Description
1 Config Information
Allows viewing and editing of library configuration settings.
1 Unit Information/Config
To view the storage slot count, drive count, and firmware revision.
2 Serial Number
To view the serial number assigned to the library.
3 Date and Time
To view/edit the current date and time settings.
4 SCSI Bus Config
To view the current SCSI bus configuration.
5 Changer Address
To view/set the changer SCSI ID.
6 Drive Addresses
To view/set individual drive SCSI IDs.
7 Changer Options
To view/edit changer options:
Disable Tray Return
Disables return of media trays to their magazines when entering Magazine
Exchange mode.
Tray Return On Power
Enables the return of media trays to the magazines upon library power on.
Disable Auto LD/EJ
Disables auto clamping and unclamping of the media tray.
Ignore Recover Errs
If library can recover from an error, it will keep operating and not report the
error.
Limit Recovery
To limit error recovery effort to four tries.
Enable All UATTN
Enable all unit attention conditions to host.
8 Passwords
To set or change passwords. To remove password protection from a menu
selection, press the check mark without entering any letters. The factory
default password is AAAA. If a password is forgotten or lost, please contact
Plasmon support.
9 RMI Information
Not supported.
2 Status Information
Allows viewing/editing of library status.
1 Element Status
To view/edit which elements (slots, drives, pickers, or I/O stations) are pop-
ulated by media trays. Individual slot status can be set to full or empty.
2 Drive States
To view a drive’s on/off state.
3 Power-On Hours
To view total hours of power to library. Useful for preventive maintenance.
Cannot be reset.
4 Unit Cycle Count
To view total cycle count since first startup. Cannot be reset.
5 Drive Load Counts
To view/reset total drive loads since last reset of count.