Polycom 6000 - Manual (Page 79)

Security
8 - 5
Security Mode requires secure access and a password for Web access.
When you enable Security Mode, the following settings are set and controlled
by the system:
To configure the system to use Security Mode:
1. Go to System > Admin Settings > General Settings > Security >
Security Settings.
2. Enable Security Mode.
When you change this setting, the Polycom QDX 6000 system restarts. Every
time a Polycom QDX 6000 system is powered on or restarts in Security Mode,
it verifies that the system software is authentic Polycom software.
Setting Restriction
AES Encryption Set to Required for Video Calls Only (or When
Available after an upgrade), configurable
Enable Remote
Access: Telnet Disabled for port 23 and 24, read-only
Enable Remote
Access: SNMP Disabled, read-only
Web Access Port Port 80 disabled with no redirect to port 443, read-only
Port 443: Available for HTTPS, read-only
Allow Video Display
on Web Disabled, configurable
Auto Answer
Settings Auto Answer Point-to-Point: Disabled, configurable
User Settings Mute Auto-Answer Calls: Hidden
Allow Video Display on Web: Hidden
Far Control of Near Camera: Hidden
Minimum Password
Length Set to 1, must be at least 1