Peavey XR 800F User Manual
Page 6
MASTER FUNCTIONS
The MASTER FUNCTIONS section describes those features that are considered master controls.
Essentially, this makes up all of the functions on the right-hand, front panel side of your XR 800F.
The areas of detail include; Effects, EQ/FLS and Monitor/Master Level Controls.
12.
EFFECTS PEAK LED:
Illuminates to indicate -6 dB of headroom before the signals being sent to the effects circuit
are clipped. Ideally, you would want this LED to light only occasionally if at all. An occasional
blink indicates that you have the levels at an optimum setting. It is advisable to listen carefully
to the output at the same time in order to determine the final setting. If you hear distortion
then one or more of the input digital effects level controls are set too high.
13. PRESET: Selects the effect preset from the list below.
EFX Presets
PRESET
NAME
TIME/SIZE
COLOR/TONE
1
Chamber
Time: 150 to 5,000 ms
Damping (High Frequency)
2
Plate
Time: 100 to 4,000 ms
Damping (High Frequency)
3
Room
Time: 150 to 5,000 ms
Damping (High Frequency)
4
Cathedral
Time: 100 to 8,000 ms
Damping (High Frequency)
5
Spring
Time: 150 to 5,000 ms
Damping (High Frequency)
6
Gate
Time: 150 to 500 ms
Damping (High Frequency)
7
Reverse
Time: 150 to 500 ms
Damping (High Frequency)
8
Delay + Reverb
Time: 0 to 225 ms
Reverb Time: 0 to 5,000 ms
9
Bright Delay
Time: 0 to 500 ms
Feedback: 0 to 99%
10
Warm Delay
Time: 0 to 500 ms
Feedback: 0 to 99%
11
Dark Delay
Time: 0 to 500 ms
Feedback: 0 to 99%
12
Ping Pong Delay
Time: 0 to 500 ms
Feedback: 0 to 99%
13
Chorus
Rate: 0.125 to 8 Hz
Depth: Best Set Full CW
14
Phaser
Rate: 0.250 to 16 Hz
Depth: Best Set Full CW
15
Flange
Rate: 0.10 to 2.5 Hz
Depth: Best Set Full CW
16
Rotary Speaker
High Speed: 0.50 to 25 Hz Width: 0 to 100% CW
14.
TIME/SIZE:
In Reverb and Delay presets (presets 1-12), this control adjusts the time of the particular
reverb or delay; in Chorus, Phaser, and Flange, it adjusts the rate of each. In Rotary Speaker
setting, this adjusts the speed of the speaker rotation.
15.
COLOR/TONE:
Adjusts the high frequency content of the effects signal. (While using a delay, this control
adjusts the feedback or depth.)
16. EFX to MON:
Controls the amount of effects signal sent to the monitor mix. This control allows effects to be
heard from the stage via the monitor.
17. EFX to MAIN: Controls the amount of effects signal sent to the main mix.
12
13
14
15
16
17
6