Using the remote, If the remote doesn’t work – Planar M46L User Manual
Page 30
20
m40L/m46L Installation & Configuration Guide
Using the Remote
The remote control operates with IR (infrared) signals going to the IR receiver
(located in the lower right corner of the screen for landscape and in the lower left
corner for portrait).
(Later, to prevent accidental adjustment of the display, you can disable the remote
control function using an RS232 command.)
If the Remote Doesn’t Work
• The batteries in the remote are dead or installed wrong.
• The remote was not aimed at the screen.
• Something is blocking the IR receiver in the display.
• IR remote action was disabled by an RS232 command.
Note:
The remote control has a large spread of its IR radiation. It is difficult from a distance to
control only one display in an array; step closer.