Polaris 700 Dragon RMK - Manual (Page 59)

56
OPERATION
Starting the Engine
1. Turn the key to the ON position. Pull the engine stop switch up to
the RUN position.
2. Carbureted models: Turn
the fuel valve on. If starting
a cold engine, flip the
choke toggle to FULL
CHOKE. Do not use the
choke if starting a warm
engine. After the engine
starts, flip the choke toggle
to the OFF position. If the
engine slows or wants to
stop, use intermittent chok-
ing to the HALF CHOKE
position.
NOTE: Do not depress the throttle until the engine starts.
3. If equipped with electric start, turn the key to START to crank the
engine. Release the key to the ON position when the engine starts.
4. If not equipped with electric start, grasp the starter handle and pull
slowly until the recoil engages; then pull abruptly to crank the
engine.
NOTE: It may require as many as eight to ten pulls to prime the fuel system
and start the engine if the fuel tank has been completely emptied.
5. Repeat the cranking procedure as needed until the engine starts.
CAUTION
Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the transmission is in reverse. Never engage
the starter when the engine is running.
CAUTION
Don't pull the starter rope to the fully extended position and don't allow it to
snap back into the housing. Damage may result. To avoid injury and/or
engine damage, do not operate the electric starter or pull-rope starter while
the engine is running.
CHOKE POSITIONS
FULL CHOKE
1/2 CHOKE
OFF