Philips H982NUD - Manual (Page 30)

English
30 DVD to Videotape Duplication
Follow the steps below to copy a DVD to a videotape. This will
be possible only if the DVD is not copy protected.
Before you begin:
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the DVD.
● Put the DVD you want to copy in the disc tray.
● Press VCR so VCR light appears on the front of the DVD/VCR.
● Turn on the TV and set it to channel 3, 4 or its Video Input.
1 Point the remote control at the DVD/VCR. Press Number
buttons 0, 0, 3. “DISC” will appear on the TV screen.
2 Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
speed are on page 60.
3 Press RECORD I to start recording. “REC” will appear
on the display panel.
4 Press DVD. Press PLAY B to play the disc.
5 To pause the recording, press VCR, then press
PAUSE k once. “REC” will flash. To resume recording,
press RECORD
I or press PAUSE k again. “REC” will
reappear.
6 To stop recording, press VCR, then press STOP C.
DISC
3,5
6
1
5
2
4 5,6
STANDBY-ON
PLAY
DVD VCR VCR/TV
OK
MENU MENU
DISC/VCR
RETURN TITLE
A-B
CLEAR/RESET SLOW
SUBTITLE ZOOM ANGLE
REPEAT REPEAT AUDIO
SEARCH MODE DISPLAY
SKIP / CH
SYSTEM
PAUSE STOP
MARKER RECORD TIMER SET
SPEED
1 2 3
7 6 5 4
8 9 0 +10
• A timer recording is not
possible during DVD to
videotape duplication.
• You cannot copy a DVD to a
videotape if you are using
Progressive Scan. Details are on
page 14.
Helpful Hints
H982NUD_EN1 3/2/06 6:56 PM Page 30