Paradyne JetFusion Integrated Access Device - Manual (Page 83)

2000-A2-GB20-10 - 64 - February 2004
Enter SDSL Auto Cycle Speed Entry to Configure
(1..14):
Type the value of the entry to configure.
3. The IAD prompts for the data rate:
Enter SDSL Data Rate (kbps):
Type the data rate (144 kbps to 2320 kbps, evenly divisible by 8000).
4. The IAD saves the configuration and displays the SDSL Configuration
menu.
Using the Debug Menu
Configur-
ing the
ADSL Inter-
face
The tasks described in this section all begin on the ADSL Configuration
menu. You should review and update each of these options as necessary,
and reset the IAD when you finish WAN configuration.
To configure the ADSL interface, Type 2 (Configure Physical Interface) on
the WAN Configuration menu to display the ADSL Configuration menu:
Figure 4–19. G7070 ADSL ATU-R Configuration Menu
5. Type 1 to select Set ADSL Standard. The IAD displays the ADSL
Standard menu.
Figure 4–20. ADSL Standard to use for Startup Menu
NOTE Commands in option D—SDSL Debug Menu—are reserved
for Paradyne network engineers.
LAN LINK LAN ACT WAN LINK VOICE POWER
JF2004
JF2008
JF2004i This section is only for configuring the ADSL WAN interface
on the JF2004, JF2008 and JF2004i.
*****************************************
G7070 ADSL ATU-R Configuration
*****************************************
1. Set ADSL Standard
D. Enable/Disable ADSL Debug Messages
*****************************************
ADSL Standard to use for Startup
*****************************************
Current ADSL Standard: Multi-Mode
1. T1.413
2. G.LITE
3. G.DMT
4. Alcatel 1.4
5. Multi-Mode
6. ADI
7. Alcatel