Paradyne ACCULINK 3151 CSU - Manual (Page 13)

11
Table 6. General Management Configuration Options (2 of 2)
Option Comments/Description Factory 2 Factory 1
Com NetMask:
Edit Edit The Subnet Mask needed to
access the device when the COM
Com NetMask:
Clear Clear
access the device when the COM
port is configured for SNMP.
Com Link:
PPP PPP
The link layer protocol for the COM
Com Link:
SLIP SLIP
The link layer protocol for the COM
port when configured for SNMP.
IPBusMast:
Enable Enable
Specifies whether the device is the
IPBusMast:
Disab Disab
Specifies whether the device is the
IP Bus Master.
None None
Def Netwk:
IPBus IPBus
The default network connection Def Netwk:
Com Com
The default network connection.
FDL FDL
Table 7. Management Trap Configuration Options (1 of 2)
Option Factory 1 Factory 2 Comments/Description
Num Trap Mgrs:
1
2–6
1
2–6
The number of trap managers
supported by the device.
Trap n IP Adr:
Edit Edit Specifies the IP address for each
trap manager. This configuration
Trap n IP Adr:
Clear Clear
trap manager. This configuration
option is repeated for all
n
managers.
None None
Trap n Dst:
IPBus IPBus
Specifies the network destination Trap n Dst:
Com Com
Specifies the network destination
for Trap Manager
n .
FDL FDL
Disab Disab
Gen Trap:
Warm Warm Specifies the general trap types to
enable: WarmStart Authentication
Gen Trap:
Auth Auth
p g p yp
enable: WarmStart, Authentication
Failure or both.
Both Both
Failure or both.
Entp Trap:
Enab Enab Specifies whether the
EnterpriseSpecific trap type is
Entp Trap:
Disab Disab
p
EnterpriseSpecific trap type is
enabled.