14 additional information, Troubleshooting, Additional information – Pioneer VSX-515-S/-K User Manual
Page 78: Additional information 14, Chapter 14
Additional information
14
78
En
Chapter 14:
Additional information
Troubleshooting
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized independent service company to carry out repair work.
• If the unit does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
Remedy
The power does not turn on.
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your
nearest
Pioneer authorized service center or your dealer for servicing.
• The unit may have been switched on using the wrong voltage setting.
Make sure you switch the
VOLTAGE SELECTOR
on the rear panel to
the right voltage for your country or region, then reset the unit
(page 81) before switching on again.
No sound is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting up
on page 14).
• Press
MUTE
on the remote control to turn muting off.
•
VSX-815/915 only
– Press
SPEAKERS
to select the proper speaker set
(VSX-815 – see
A and B speaker systems
on page 23, VSX-915 – see
Switching the speaker system
on page 71).
• Press
SIGNAL SELECT
to select the proper input signal (see
Choosing the input signal
on page 40).
No image is output when a
function is selected.
• Make sure the component is connected correctly (refer to
Connecting up
on page 14).
• Select the correct component (use the input select buttons).
•
VSX-815/915 only
– Check
Assigning the component video inputs
on
page 75 to make sure you’re assigned the correct input.
• The video input selected on the TV monitor is incorrect. Refer to the
instruction manual supplied with the TV.
VSX_815-915.book.fm 78 ページ ２００５年３月１日 火曜日 午前１０時２２分