Paxar Monarch 9855 - Manual (Page 22)

18
751 Printer did not sense a black mark when expected. Press Escape/Clear
and try to continue printing. Change supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Check for a ribbon jam or remove any slack in the ribbon by turning the
take-up reel clockwise. Load a new ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.
757 Load supplies (supply length mismatch). Press Feed/Cut.
758 Either the supply is not seen, the on-demand sensor is broken, or a label
was removed too quickly. Check for a label jam or reload supplies.
763 Waiting to dispense label. Press Feed/Cut.
765 The printhead has less than 8 bad dots and can shift bar code fields to
avoid bad dots. Press Escape/Clear to continue printing.
768 Printhead has more than 8 bad dots within the format area or is not
connected. Replace or connect printhead as necessary.
The printer does not recalibrate (feed a blank label) after any RFID error. Refer to
the RFIDMP Application Notes (on our Web site) for more information.
R F I D P r i n t e r S p e c i f i c a t i o n s
Height: 13 inches (330 mm)
Width: 12.5 inches (318 mm)
Depth: 17.3 inches (439 mm)
Weight: 29 lb. (13.2 kg)
Shipping Weight: 34 lb. (15.5 kg)
Power Source: 90-264 VAC with autoselect 50/60Hz
Printhead: Thermal at 4 inches (1012 mm) wide
203 dpi (8.0 dots per mm)
Optional 300 dpi (11.8 dots per mm)
Speed: 2.5, 4.0, 6.0, 8.0, and 10.0 ips (inches per second). 12.0
ips (305 mm) printing is an option that must be purchased
separately. 2.5 is the default for serial bar codes.
Note:
The RFID printer pauses while programming the
RFID tag.