National Instruments NI PXIe-8105 - Manual (Page 75)

Index
© National Instruments Corporation I-5 NI PXIe-8105 User Manual
R
RAM
DDR2 SO-DIMMs from National
Instruments (note), 2-15, 4-4
upgrading, 2-15, 4-4
related documentation, viii
S
safety specifications, A-4
saving BIOS changes without exiting, 2-11
Serial ATA controller, using SCSI hard drive in
addition, 4-1
Serial ATA Hard Disk, 1-4
serial port, 3-1
setting up the NI PXIe-8105 BIOS, 2-4
shock and vibration specifications, A-4
socket 479 1 CPU, 1-3
SO-DIMM logic block, 1-3
software
See also drivers
installed on your hard drive, 2-12
LabVIEW, 1-4
LabWindows/CVI, 1-5
Measurement Studio, 1-5
National Instruments software, 1-4
NI resources, B-1
NI-DAQmx, 1-5
NI-VISA, 1-6
specifications, A-1
CE compliance, A-5
electrical, A-2
electromagnetic compatibility, A-4
operating environment, A-2, A-3
physical, A-2
safety, A-4
shock and vibration, A-4
storage environment, A-3
Waste Electrical and Electronic
Equipment (WEEE), A-5
storage environment specifications, A-3
super I/O logic block, 1-4
support, technical, B-1
system CMOS, 2-11
system reset pushbutton, 3-16
T
technical support, B-1
training and certification (NI resources), B-1
trigger, 3-11, 4-6
connector location and pinout (figure),
3-11
connector signals (table), 3-11
troubleshooting
CMOS reset, 5-2
controller does not boot, 5-1
damaged module, 5-2
NI resources, B-1
video display, 5-2
U
Universal Serial Bus (USB), 3-10
connector function, 1-4
connector location and pinout
(figure), 3-10
connector signals (table), 3-10
overview (table), 3-1
Universal Serial Bus (USB) connector, 3-1
V
VGA
location and pinout (figure), 3-3
overview (table), 3-1
video, 3-1
See also VGA
driver installation, 4-3