NetComm 3G Wireless Router User N3G005W - Manual (Page 37)

YML894 Rev3 N3G005W 3G Wireless Router User Guide N3G005W 3G Wireless Router User Guide
www.netcomm.com.au 3
N3G005W
Click Save to save the settings and Undo to cancel.
To Configure WDS (Wireless Distribution System) click on WDS Setting button and you will be presented with the
following page.
WDS is used to wirelessly connect multiple Access Points (in WDS mode), and in doing so extends the wireless
infrastructure to locations where cabling is not possible or inefficient to implement.
Notes: Be sure you understand the purpose of WDS mode before continuing with the configuration, and be aware that not all Access Points
can be use in WDS mode.
To enable WDS please make sure to tick the Enable tick box for Wireless Bridging.
And then type in the MAC address of the remote WDS unit in the Remote AP MAC list. Or you can copy the one
from the Scanned AP’s MAC list. This router can accommodate up to 6 remote MAC addresses.
Click Save to save the settings and Undo to cancel.