National Instruments VXI-USB - Manual (Page 60)

Index
© National Instruments Corporation I-3 VXI-USB User Manual
S
safety specifications, A-3
selecting controller in VISAIC (figure), 3-4
serial number, determining, D-2
shock and vibration specifications, A-2
software
configuration, 2-6
installation, 2-1
completing, 2-2
verification, 2-6
software (NI resources), E-1
specifications, A-1
CE compliance, A-4
cleaning, A-4
electromagnetic compatibility, A-3
environmental, A-1
physical, A-2
power requirement, A-2
requirements, A-1
safety, A-3
shock and vibration, A-2
USB compatibility description, A-3
VMEbus capability codes, A-4
support, technical, E-1
T
technical support, E-1
training and certification (NI resources), E-1
troubleshooting (NI resources), E-1
U
USB compatibility description, A-3
USB device, plugging into USB ports vs. into
mainframe, D-1
USB system (figure), 2-4
user-configurable settings, C-1
V
VISAIC, 3-10
selecting controller in (figure), 3-4
successful viIn access in Register I/O tab
(figure), 3-5
VISAIC (figure), 3-10
VME devices, handling, D-2
VMEbus capability codes, A-4
VXI 3.0 specification support, 1-2
VXI bus tab default settings (table), B-3
VXI, programming for, 3-5
VXIbus transfers, optimizing, 3-7
VXIbus, CLK10 routing, C-2
VXI-USB
advanced configuration options, 1-4
application development, 3-1
common questions, D-1
configuration, 2-1, 3-2
default configuration settings, B-1
default configuration settings
(figure), B-2
default software settings, B-3
determining serial number and hardware
revision, D-2
determining which NI-VXI utility to use
with, D-2
ensuring that system is up and
running, D-3
expanding system, D-1
front panel features, 1-3
front panel LEDs, 1-3, D-3
getting started, 1-1
hardware
configuration, 2-3
default settings (table), B-3
description, 1-2
installation, 2-4
installation, 2-1, 2-5
introduction, 1-1