National Instruments NI USB-6008/6009 User Manual
Introduction, User guide and specifications
Advertising
USER GUIDE AND SPECIFICATIONS
NI USB-6008/6009
This user guide describes how to use the National Instruments
USB-6008/6009 data acquisition (DAQ) devices and lists specifications.
Introduction
The NI USB-6008/6009 provides connection to eight analog input (AI)
channels, two analog output (AO) channels, 12 digital input/output (DIO)
channels, and a 32-bit counter with a Full-Speed USB interface.
Note
This manual revision updates naming conventions to reflect the conventions used in
NI-DAQmx. Table 1 notes the correlation between the old and updated names.
Table 1. Digital Output Driver Type Naming Conventions
Hardware Functionality
NI-DAQmx Terminology
Open-drain
Open collector
Push-pull
Active drive
ni.com/manuals
Deutsch
Français
Advertising
Table of contents
Document Outline
- NI USB-6008/6009 User Guide and Specifications
- Introduction
- Dimensions
- Safety Guidelines
- Related Documentation
- Installing the Software
- Installing the NI USB-6008/6009 Device
- I/O Connector
- Signal Descriptions
- Analog Input
- Analog Input Circuitry
- Analog Input Modes
- Connecting Differential Voltage Signals
- Figure 8. Connecting a Differential Voltage Signal
- Figure 9. Example of a Differential 20 V Measurement
- Figure 10. Exceeding ±10 V on AI Returns Clipped Output
- Connecting Referenced Single-Ended Voltage Signals
- Figure 11. Connecting a Referenced Single-Ended Voltage Signal
- Digital Trigger
- Analog Output
- Digital I/O
- Event Counter
- Reference and Power Sources
- Specifications
- Where to Go for Support