NetComm NP6800 - Manual (Page 18)

www.netcomm.com.au Rev.1 - YML655
Page 18 NP6800 - Wireless LAN Access Point
Configuring the Access Point via Ethernet
The SNMP Manager provides a GUI custsomisation tool which can be accessed by your
ethernet or wireless connection. Before using the SNMP Manager you will need to assign a
temporary IP address.
Assigning a Temporary IPAddress
If you wish to use the SNMP Manager utility to configure the Access Point, you must assign a
temporary IP address to your computer.
1. Click on Start ->Settings->Control Panel, and then double-click on the Network icon.
2. Select the network adapter associated with the TCP/IP and click Properties.
3. Write down your current settings in order to restore your TCP/IP configuration.
4. Select Specify an IP address and enter the following values:
IP Address: 192.168.168.50
Subnet Mask: 255.255.255.0
5. Click OK and click OK again in the Network window.
6. Restart your computer and continue .
Once you have completed the Access Point configuration, you can set the computer back to its
previous settings. For example, to “Obtain an IP Address automatically.”