Nikon LS8000 - Manual (Page 70)

60
Step 3—Insert the Holder
After confirming that the status LED is glowing steadily, slide a holder into the holder slot as
shown below, with the insertion guide up and pointing toward the scanner. Do not insert the
holder at an angle. Once the holder has been inserted as far as the insertion guide, the scanner’s
loading mechanism will be activated and the holder will be fed into the scanner automatically.
Remove your hands from the holder when loading starts. Loading will stop when the holder is
in scanning position.
Insertion guide
Inserting Holders
Holders can not be inserted into the scanner if the sliding cover is not fully open.
When inserting holders in the scanner, do not use force. When a holder is inserted, the scanner
readies the loading mechanism. Removing the holder or otherwise interfering with loading can
cause scanning errors. Do not attempt to forcibly remove the holder during or after loading.
When ejecting the holder, always use the button on the front of the scanner or the eject button
in the Nikon Scan scan window.
If the holder does not load automatically when inserted, remove the holder and try again. Before
insertion, remove any dust or lint with a blower.