Numark Industries AXIS 9 - Manual (Page 26)

-14-
SPECIAL EFFECTS
EFFECT SELECTION (Single Mode): To select and activate an effect tap on
it’s button, it will light to indicate activation and effect will indicate in the
display. To put the effect into hold mode or active alternate effects press the
center button. The button will light indicating the hold has been activated and
hold will show in the display. To release any button, tap it once again.
EFFECT SELECTION (Multiple Effect Mode) (AXIS 9 ONLY): In order to
activate/deactivate this mode press PROG + HOLD. The display will indicate
“MULTI” or “NO MULTI”. Press an effect and move the wheel to the desired
parameter. Then press a second effect. The first effect will flash while the
current effect will be solid. To change effects, select the effect you want. To
release, press the “current/solid” effect a second time.
You can use a combined effect value of 4 effect values at the same time.
These values are:
SCRATCH : 0
PHAZE : 2
SONAR : 2
SLIDE : 2
ECHO/A.D. : 1
CHOP/PAN : 1
ISO/KILL : 1
REVERSE/BLEEP : 0
Scratch and Reverse are always possible. If more than the allowed values are
attempted, they will not activate.
For example:
• You can have Echo, ISO, Scratch and Sonar
• Phaze and Slide with Reverse
• You can not have Phaze, Sonar, and Echo
EFFECT PARAMETER SELECTION: Once an
effect is active, rotate the wheel (AXIS 8) or inner
touch wheel (AXIS 9) to the desired parameter
value. The parameter value for most effects will
show in the display above the effect indication.
Note: For all effects except reverse, you will need to
activate pitch bend via the pitch bend buttons. On
the AXIS 9 you can also use the outer non-touch
section of the jog wheel.
EFFECT PARAMETER PRESET: Press on the desired effect and rotate the
wheel (AXIS 8) or inner touch wheel (AXIS 9) without releasing the button.
When the desired parameter is reached in the display, release the button. If an
effect is already playing, the new parameter will be heard upon button release.
If the effect is not active, then the next time the effect is activated it will be set
to play from this parameter in “hold” mode. If you wish to preset an alternate
effect such as SLIDE, PAN, or KILL press the hold button first, then hold down
the effect button and spin the wheel as described above.