Radio Shack PPGW 1040 - Manual (Page 4)

PARTS DESCRIPTION
3
TROUBLESHOOTING
If you are having trouble with your amplifier, these instructions below may
help you before you call a service technician.
1. Check that the power cord is plugged into a power outlet.
2. Check that the power is turned on at the outlet. If you are at a gig, make
sure the stage power has been turned on.
3. Check that the control knobs have been sufficiently turned up.
4. Check that the instrument is correctly plugged into the amplifier, both at
the instrument and at the amplifier input.
5. Check the instrument lead -faulty leads are one of the most common
causes of problems.
6. Check that the volume is turned up on the instrument.
If your amplifier still does not function, contact your local dealer or an
authorized service agent.
6
WIRELESS TRANSMITTER
LOW BAT
ON MUTE
MIC/LINE AUDIO POWER ATTENUATION POWER
OFF ON 0dB -20dB
9 V
+
AUDIO OUTPUT JACK
AUDIO SWITCH
VOLUME SWITCH
POWER SWITCH
LOW BATTERY LED
POWER LED
BATTERY COVER
ANTENNA
BELT CLIP
1. Open the battery cover to install a 9V battery as per correct polarities.
Move the power switch to ON position, the power indicator will be
green to show normal operation. If the LOW BAT indicator
2. Plug the 3.5mm plug of supplied connector to screw-lock socket of
transmitter. Plug the other end 6.35mm plug to your guitar output jack.
3. ATTENUATION is for volume adjustment. Move it to 0dB position to
get normal volume output, or to -20dB position to reduce distortion
and avoid humming.
4. If the system will not be used for a long time, please switch off the
transmitter to avoid power consumption.
indicator
illuminates, this indicates the voltage is not enough for operation.
Replace the 9V battery.
Operation
AUDIO CABLE
TROUBLESHOOTING