Raymarine Wind & Close Hauled Wind Instrument ST60 - Manual (Page 29)

Chapter 3: Installation 17
4. Snap the low-profile bezel (8) in position over the instrument, so that the rub-
ber keys are correctly located in the holes on the bezel.
CAUTION:
It is essential that only screws of the correct size are used to
secure the instrument to the bezel. Failure to observe this caution
could result in damage to both the instrument and the bezel.
5. Using the four, self-tapping screws (9) provided, secure the instrument and
bezel together. Fit the screws from the rear of the instrument and tighten
them sufficiently to secure the instrument and bezel together. DO NOT OVER-
TIGHTEN.
Flush mounting procedure
Flush mount your instrument (see the
Flush mounting illustration) as follows:
1. Assemble the ST60 instrument and low-profile bezel as described under Fit-
ting the low-profile bezel .
2. Ensure that:
• The panel on which you intend to mount the instrument is between
0.12 in (3 mm) and 0.78 in (20 mm) thickness.
• The selected location is clean, smooth and flat.
D4356-2
7 8 9
Fitting the low profile bezel