Raritan Engineering SeaEra Toilets - Manual (Page 7)

7
Mounting Toilet
Mounting surface must be flat and solid.
1. Install seat on toilet.
2. Remove motor cover.
3. Place toilet where it will be located.
Make sure there is room to route hoses.
Make sure seat will open properly.
4. Mark location of toilet base mounting holes
on mounting surface.
5. Drill holes for toilet mounting bolts/screws.
NOTE: Hole size will depend on type of bolt/
screws used (5/16" [8mm] size bolts/screws are
recommended).
6. Secure toilet to surface.
INST
ALLA
TION
Additional Parts Required
•
Four stainless steel mounting bolts or lag
screws (minimum 1/4" [6mm]) and washers
• 1" (25mm) or 1 1/2" (38mm) I.D. discharge hose
• 3/4" (19mm) I.D. reinforced intake hose
• 3/4" (19mm) and 1" (25mm) or 1 1/2" (38mm)
hose clamps (two for each connection below
waterline)
• Wire
• Terminals
• Fuse/circuit breaker
Parts Included
All Complete Toilets
Toilet Bowl
Seat and Cover
Lower Base Assembly
Motor Cover
Push Button Switch
Sea Water Model
3/4" Hose Barb - straight fitting (2)
3/4" Hose Barb - 90° fitting
Plug Fitting
In-Line Strainer with fittings
3/4" Stainless Steel Hose Clamps (2)
Pressurized Freshwater Models
Atmospheric Vacuum Breaker (PLAVB0-5)
Solenoid Valve with fittings
Solenoid Valve Mounting Bracket
Tools Required
• 5/16" nut driver
• Wrench or screw driver
• 5/8" (16mm) drill bit
• Bit for drilling mounting surface
• Wire cutters
• Wire terminal crimpers
• Hose cutters
• Tape measure