Rosen Entertainment Systems viocecom 1000 - Manual (Page 17)

VoiceCom 1000™ Operating the System
The phone then starts device recognition. In the list of the devices found by your
phone, select " VoiceCom 1000™". In the course of the procedure of pairing your
phone you will be asked to input your PIN or code (also passkey). Please enter
the digit sequence "1234" then. After a short time the phone should report
that the device has been paired. You can also abort the pairing at any time by
pressing the "right" key.
If the pairing is not successful, please turn to the "troubleshooting" section.
Bluetooth ® Connection
If the phone does not set up a connection automatically to the hands-free
speaking system after successful pairing, select the name of the paired phone
under "paired devices" in the menu of your VoiceCom 1000™ and then the item
"Connect". A connection is always set up by the hands-free speaking system if:
• The Ignition is turned on and the phone which was last connected is found
or if one of the paired phones is found.
• You can also select a paired phone in the menu under "Paired Devices" and
set up a connection to this. A precondition for setting up a connection is:
• That the phone is in range (typ. < 30ft.),
• There is no other Bluetooth
® connection at present,
• Both partners still have the connection passkey agreed on during
the pairing procedure.
A connection usually remains set up until the device has been disconnected
explicitly or terminated by, for example, continuously exceeding the range.
Some phones end the Bluetooth ® connection in the headset profile after every
audio connection. In this case, you must first restore the connection in order to
use the VoiceCom 1000™ dialing functions (e.g. by pressing the green key).
The connection is restored after a few seconds.
When the connection is being set up for the first time, the VoiceCom 1000™
tries to load the phone book from the connected mobile phone. This might take
some time if there are a lot of entries. The progress bars show what stage the
process has reached. You cannot use the VoiceCom 1000™ hands-free speaking
functions until this process is over. As soon as the synchronization of the phone
book is over, you can use the arrow keys to leaf through it directly. Keep the
key pressed down to jump very quickly from one initial letter to the next.
-17-