Roksan Audio KMA-2/3 - Manual (Page 3)

Roksan Audio ltd Kandy Power Amplifier 2/3 Channel User Manual
CLASSIFICATION: General Use Version 1.0
All specifications are liable to change without notice. E&OE Page 3 of 10 ENGLISH
AC MAINS SUPPLY
Your Kandy Amplifier is set to operate from a fixed supply voltage which is marked on a label next to the mains
input plug. Before connecting the mains lead please check that your mains supply corresponds to this label as
below:
230V Products ………………………………….Voltage Range: 220V – 240V
115V Products ………………………………….Voltage Range: 100V – 120V
The mains lead supplied with this product has an IEC mains socket that plugs into the IEC connector on the
unit’s rear panel. The other end is normally attached to the appropriate mains plug for your country. In the UK
this is the standard UK13A plug.
This plug should ordinarily not be removed from the lead. If you do remove it, please dispose of it safely so that it
cannot be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that you obtain
from your dealer a complete replacement lead.
Should you move to another area where either the mains voltage or the mains plugs are different from those as
supplied with your Integrated Amplifier, please contact the appointed ROKSAN distributor for assistance.
Please observe correct mains polarity at all times.
The Kandy Power Amplifier mains fuse is located on the rear panel next to the IEC mains connector. This must
only be replaced by the fuse of the type and rating as described on the fuse rating label on the rear panel of the
unit.
This product requires connection to electrical earth (ground). The earth wire (in the UK this is colour coded
green/yellow) of the mains cable supplied with your Power Amplifier must be connected to a suitable grounding
point established for this purpose by your electricity supply company. If you are in any doubt, consult a qualified
electrician.
If the equipment is likely to be unused for some time, unplug it from the mains supply.
GENERAL CAUTIONS
FCC WARNING
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this
equipment if unauthorised modifications are made.
INTERFERENCE
Properly installed, this unit should not cause harmful interference to radio communications, There is, however, no
guarantee that such interference will not occur in a specific installation. If interference arises (which you can
determine by switching the unit off and on) you could try to remedy matters by the following:
• Re-orient or re-locate the receiving antenna
• Increase the distance between the Kandy Amplifier and receiver
• Connect the unit to a different mains circuit from that of the receiver
• Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice
LOCATION
Your Kandy Power Amplifier should be located in a well ventilated area and kept away from sources of heat, dust
and humidity and from direct sunlight.
The Kandy Power Amplifier may be positioned either as a free standing unit or alongside another audio/video
product.
Never place the Power Amplifier on carpet or any surface likely to hinder normal ventilation.
Never allow liquids or other objects to fall into the unit.
This unit contains no user serviceable parts. Do Not remove any panels or attempt to service it yourself.
Unauthorised servicing will void the warranty.
C A U T I O N S K a n d y Power Amplifier 2/3 Channel