Revox Recontrol M207 - Manual (Page 9)

Re:control M207 User’s Manual
6
1.3.1 Precautions for using battery
Please pay attention to the following instructions:
1. Be sure that the positive (+) and negative (-) polarities of each
battery match the polarities indicated in the compartment.
2. Do not expose the batteries to excessive heat or flame.
3. Keep the batteries away from children.
4. Low power batteries will reduce the effective distance of the
unit.
5. Do not mix different type of batteries or mix new and used
batteries to use at the same time.
If you use Ni-MH rechargeable batteries, please pay
more attention to the followings.
a. Before the first use, please charge the batteries for
10 hours.
b. Do not recharge the batteries with an unqualified
charger.
c. When the battery low power warning icon appears,
please recharge batteries right away.
d. Please renew the batteries immediately when its
running time left is lower than half of preliminary after
they are fully recharged.
Warning: When the battery low power warning icon
appears, you may not enter the Setup Menu to
operate the functions such as using learning function,
adding a Macro, or deleting devices.
1.4 Turning the touch screen on
Figure 2-2: Turning the LCD on
There are three ways to turn on
Re:control M207:
1. Picking up the Smart Remote:
The motion detector design will
turns the Re:control M207 on.
2. Pressing any rubber key.
3. Taping the LCD touch screen.