RCA T19067 - Manual (Page 19)

Using the Remote
1 7
CLEAR Removes any menu or display from the screen and returns
you to TV viewing. Also exits the GUIDE Plus+ menu system. Allows
you to change menu entries or clear a timer recording. Resets time
counter to 0:00:00 when displayed.
Number Buttons (0-9) Enters channel numbers, digits for
programming the remote, and time settings directly though the
remote control. To enter a two-digit channel, press the two digits.
To enter a three-digit channel, press and hold the first digit, release,
then add the second two. For example: to tune to channel 123, press
and hold 1, release, press 2, then 3.
INPUT In TV/VCR mode, press to toggle through the available input
sources (VIDEO 1, VIDEO 2, current channel).
ANTENNA Functions as TV/VCR button in VCR mode and
TV/receiver button in SAT•CABLE mode.
REVERSE Rewinds the tape when the TV/VCR is stopped. Searches
the picture in reverse during playback.
PLAY Plays a tape.
FORWARD Fast forwards the tape when the TV/VCR is stopped.
Searches the picture in forward motion during playback.
REC•VCR+ Starts TV/VCR recording. Used for express recording.
When in the GUIDE Plus+ system, pressing this button brings up the
one-button recording screen. When not in the GUIDE Plus+ system,
pressing this button will record the program you are currently
viewing; however, if you have set a GUIDE Plus+ system-timed
recording, that recording will interrupt the TV/VCR recording.
STOP Stops functions such as record, play, rewind, fast forward,
and pause.
PAUSE Pauses the tape during playback. Pauses the tape during
recording to prevent recording of unwanted scenes.
TRACKING - and + (Tracking Down and Up) Lets you manually
adjust tracking to reduce the streaks that may appear in the picture
during playback.
EDIT Pressing EDIT during playback pauses the tape. Press again to
resume playback. Also, if FR. ADV is pressed, the tape advances
frame-by-frame. One way to resume playback is to press EDIT.
FR. ADV (Frame Advance) Fast forwards the tape through a
commercial when a tape is playing. Advances the tape one video
frame at a time when the tape is paused.
Using the INPUT Button
Use the INPUT button to toggle through the available input sources
and view the component you have connected to the TV/VCR.
1. Press TV to place the remote in TV mode. Make sure that the
component you want to view is turned on.
2. Press INPUT to tune to an available input source.
3. Continue to press INPUT to scroll through the input sources.
Modes of Operation
Because this universal remote can
control several different components
(cable box, another VCR, etc.), it uses
operational modes triggered by the
component buttons. For example if you
want the remote to control the TV/VCR,
you would press the TV button to put
the remote into TV mode before you
could control the TV/VCR.