Radio Shack PRO-2067 - Manual (Page 26)

26
3. When the scanner finds an active
frequency, it stops searching. To
save the frequency into a channel
in the channel storage bank (bank
9 only), press
FUNC then ENTER .
Stored @ 9xx appears on the
bottom row of the display ( xx is
the channel number). Press ▲ or
▼ to continue searching for addi-
tional active frequencies.
Notes:
• During a search, you can manu-
ally change the band mode or fre-
quency step. See “Changing the
Receive Mode” on Page 33 or
“Changing the Frequency Step”
on Page 33.
• If channel storage bank 9 does
not contain any empty channels,
Bank 9 full. appears on the
display’s lower line.
• To pause the search, press FUNC
then TUNE . To begin searching
again, press SEARCH .
Storing a Frequency to a
Specified Channel
1. When the scanner stops on the
desired frequency, press FUNC .
2. Press TUNE .
3. Press MAN .
4. Select the desired channel using
a number key then press MAN
again.
5. Press PROG .
6. Press FUNC then TUNE to store
the frequency.
7. If desired, press SEARCH to return
to the search mode.
Changing a Search Range
with a Preprogrammed Range
You can replace the search range with
one of the preprogrammed ranges.
1. Press FUNC then SEARCH to
enter search program mode. PSR
and the search bank number of
the current range appear at the
display’s upper left corner.
2. Press ▲ or ▼ to select the search
bank you want to replace.
3. Press FUNC then 5 . ?SR and the
search bank number appear at
the display’s upper left corner.
Note: If you do not press 5 within
about 3 seconds after you
pressed
FUNC , the scanner stops
search program mode. Start over
at Step 1.
20-196a.fm Page 26 Friday, June 2, 2000 3:48 PM