Oracle Audio Technologies Sun Oracle SunDual 10GbE XFP - Manual (Page 41)

Chapter 4 Network Configuration 31
4. Plug the Ethernet cable to the adapter port.
5. Power on the system.
6. Press the F2 key or the Control/E keys to go to the BIOS.
7. Check and make sure that the boot order of Hard Drive is higher than network
devices.
8. Refer the boot-device-order image.
The reconfiguration boot attaches the driver to the adapter. You can now
configure the driver parameters for your Sun x8 Express Dual 10 Gigabit Ethernet
Fiber XFP Low Profile Adapter.
9. Press the F10 key to save the boot configuration changes and exit.
System should reboot after saving the boot configuration.