Optiview 2.28.06/4.37 - Manual (Page 14)

- 14 -
1. To preset a position of the PTZ camera:
a. Select a camera number that you want to configure. Press the “SP Dome” button. Press a
preset number on this keypad shown below:
b. Adjust the camera on your preferred settings on angle position, focus, iris and zoom using the
PTZ control panel shown here:
c. When finished setting that up, press “SET” button. Note that the pre-programmed keypad on
the left as shown below will change to blue color number icon. Blue color icon means there is
a pre-programmed preset on this button for the PTZ camera currently selected.
V. Color Adjust