Toshiba FT-8001 AW - Manual (Page 19)

PROBLEM
The handset does
not ring or receive a
page.
CHARGE LED does
not light when the
handset is placed on
the base.
Noise or
interference.
The unit does not
operate properly.
When the handset is
returned to the base
unit with the volume
level set at High, a
momentary squeal
or howling sound
may sometimes be
heard.
SOLUTION
• The handset is located too far away from the base or the
battery has been discharged.
→Return the handset to charge when your call is
finished.
• The digital security code is changed.
→Remove the handset from the base unit and press
and hold PAGE . While the handset is emitting, return
the handset to the base unit.
• The battery is low.
→Place the handset on the base unit to recharge.
• The charging contacts of the handset and the base are
not clean.
→Clean them with a dry cloth.
• The AC adaptor of the base unit is disconnected.
→Plug the AC adaptor firmly into the base unit and AC
120V outlet.
• The handset is not on the base.
→Place the handset on the base properly
• The handset is too far from the base unit.
→Bring the handset near the base unit.
• The battery is low.
→Place the handset on the base unit to recharge.
• The base unit is located in a place with high
interference.
→Relocate to another outlet.
• Interference from TV, Microwave oven, Computer and
electrical appliances.
→Press
CH
to select a clearer channel, or relocate the
base unit.
• Excessive line noise.
→Check with another telephone.
• The volume control is set too high.
→Reduce volume to lower setting.
• The base antenna is not in a vertical position.
→Lift the antenna to a vertical position.
• The phone needs to be reset.
→Disconnect the AC adaptor and reconnect it after a
few seconds.
• This is normal.
→It may be prevented by changing the volume setting
to Medium or Low before returning the handset to the
base unit.