TANDBERG Codec C90 D14128.02 - Manual (Page 48)

D14128.02—NOVEMBER 2008 48
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us About the API
xPreferences ?
xpreferences usage:
xpreferences outputmode <terminal/xml>
OK
About xPreferences
The xPreferences command is used to set various preferences for the
RS-232/Telnet/SSH sessions.
Each session can define preferences individually.
IMPORTANT! This command has various settings to define the
formatting of the XACLI output. It is therefore important to define
settings to match the parser used on the control system. XACLI is
designed to make parsing of data from the TANDBERG Codec C90
very simple.
xPreferences output mode:
Terminal: Line based XACLI output for use with line based control •
systems
XML: Pure XML output for use with control systems that
•
understand XML. NOTE! This mode is to be considered
experimental in version 1 of the software. Its format WILL
change in next version.
To get an overview of the supported xPreferences commands and
their value space, type
? or help after the xPreferences:
xPreferences ? •
xPreferences help •