Tascam 788 - Manual (Page 107)

12 – MMC and MIDI functions–Control Change messages
TASCAM 788 Digital PortaStudio
107
Effect Control Change messages
The parameters of the two internal effectors can also
be changed using Control Change messages.
The bank (user or preset) and effect number are
selected before the parameters are changed. This will
load the appropriate effect settings, so that the effects
of the Control Change settings can be auditioned.
The MIDI channel number of the message is used to
determine which effector is affected by the message:
The parameters to be changed in this way are
accessed following the table below.
Note that the parameter to be accessed must first be
selected using the Non-Registered Parameter Num-
bers as given here in this section:
NRPN values for multi-channel and stereo dynamics processors
26 Aux Pan 1 through 64 through 127 = L63 through C through R63
27 Cue Level 0 through 100 through 127 = – ∞ through 0 through +6 dB
28 Cue Pan 1 through 64 through 127 = L63 through C through R63
80 EQ SW 0, 1 = OFF, ON
81 Effect Post 0, 1, 2 = OFF, PRE, POST
82 Aux Post 0, 1, 2 = OFF, PRE, POST
a.These parameters and only these parameters, apply to the master section on MIDI channel 16.
Control No Parameter Range
MIDI channel Target Remark
1 – 8 Channel dynamics ch1 through ch8
9 Stereo dynamics -
10 Stereo effect1 (for EFFECT1)
11 Stereo effect2 (for EFFECT2)
12 Multi effect -
Control
Change
Effect Range
0 Bank select (MSB) 0
32 Bank select (LSB) 0 = Preset, 1 = User
6 Data entry (MSB) (for effect parameter)
38 Data entry (LSB) (for effect parameter)
96 Data increment (for effect parameter)
97 Data decrement (for effect parameter)
98 NRPN (LSB) (select effect parameter
number)
a
a.The 788 makes extensive use of Non-Registered Parameter
Numbers (NRPNs) in order to address the large range of parame-
ters available for the effects. These NRPNs are given below:
99 NRPN (MSB) (select effect parameter
number) *1
NRPN Parameter Range
00 00 Threshold 0 through 30 = -46 through -16 dB
00 01 Attack 0 through 15 = 0.1 through 0.6, 0.8, 1.0, 1.5, 2.0 through 6.0, 8.0, 10.0 msec
00 02 Ratio 0 through 8 = 1.0:1, 1.1:1, 1.3:1, 1.6:1, 2.0:1, 2.7:1, 4.0:1, 8.0:1,
∞
:1
00 03 Post Gain 0 through 30 = 0 through 30 dB
00 04 Switch 0, 1 = Off, On