Taiwan Electrical & Electronic Manufacturers N930R - Manual (Page 65)

Inserting Flash Memory Card
To insert a flash memory card into the slot is similar to ExpressCard. You only need to pay
more attention whenever insert the flash memory card into the slot with the correct side.
For MMC and SD card, you should position the copper connector at the bottom side. For
Memory Stick card, you should position the copper connector at the topside. All of these
cards should be located at the center of the slots in inserting.
Only one correct side can be accepted for the 4 in 1 card slots. If you cannot insert the card
into the 4 in 1 slot or you had inserted the card but it is not recognized by the computer, ple-
ase remove the card and turn the card upside down and insert it again. To prevent the dama-
ge made both on card and the slot, never forced an entry into the slot with incorrect side.
Removing Flash Memory Card
It is similar to ExpressCard for removing a flash memory card from the slot. You should first
disable the card setting in the system as described in the former section.
To remove the flash memory card, you should only pull out the card by finger, there is no
release button for flash memory slot.
Eng
lish
Slot Card type Copper connector
4 in 1 SD (Secure
Digital)
MMC
(MultiMedia
Card)
MS (Memory
Stick)
MS_Pro Bottom side
Bottom
Top side
Top side
MANUAL INGLES OK 20/7/06 11:40 Página 64