Tascam GA-100CD - Manual (Page 9)

2 – Part names and functions
TASCAM GA-100CD

9 0 q w e r t
8
CLEAN/OVERDRIVE KEY SECTION OVERDRIVE SECTION MASTER SECTION
Clean/overdrive key section
8 CLEAN/OVERDRIVE key
Select the clean or overdrive channel.
The
CLEAN (green) light or the OVERDRIVE (red)
light is lit according to your selection. This key also
determines the effect bank. (See “Using effects” on
page 16.)
Overdrive channel section
The preamp OVERDRIVE CHANNEL controls function
when the red OVERDRIVE indicator is lit in the
CLEAN/OVERDRIVE key section.
9 GAIN knob
Change the amount of distortion by adjusting the
input gain. This channel provides a large amount of
distortion even at low GAIN levels.
0 VOLUME knob
Use this knob to adjust the volume without changing
the sound character.
q BASS knob
Adjust low frequencies.
w MIDDLE knob
Adjust mid-range frequencies.
e TREBLE knob
Adjust high frequencies.
Master section
r MAIN MASTER VOLUME
Adjust the volume of the total output signal sent to
the main speaker (12-inch). In addition to the guitar
preamp output, the effects output can also be sent to
the main speaker.
t SUB MASTER VOLUME
Adjust the volume of the total output signal sent to
the 2 sub-speakers (5-inch). In addition to the CD
Trainer, the effects output can also be sent to the
sub-speakers.
Effects
p a s d
y u i o f g
Effects section
Use to set the built-in effects.
y Effect selection keys ( § , ¶ )
Use these to select one of the effects – delay,
panning delay, flanger, phaser, chorus, tremolo,
auto-wah or pitch shifter. The indicator lights next to
the selected effect.
u BANK display
Shows the currently selected bank number.
i Bank selection keys ( § , ¶ )
Select from the effects preset banks. (See “Changing
banks” on page 16.)