UTStarcom UT-300R2 - Manual (Page 33)

Chapter 4 Web-based Management 31
Figure 13 WAN Settings - Static IP
1 From the WAN Setting page, select the PVC you want to
configure from the seven available PVCs, using the drop-
down menu.
2 You can also specify the VPI/VCI numbers (assigned to
this PVC by your ISP) that will be used to uniquely identify
this PVC to your ISP. You can also enter of modify these
two numbers later during the configuration process.
3 Click the Add button, at the bottom of the page, to add the
new configuration to the list of active PVCs. This will open
the
WAN Setting configuration screen, shown above.
4 Click to select the RFC2684Bridged radio button listed in
the WAN Type options list. The menu will change to offer
a different set of configuration options, as shown above.
5 Select the Connection Type from the options to be Static
IP , by clicking the radio button.