Vivotek SD7151 - Manual (Page 6)

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
6 - User's Manual
Hardware Reset
There is a reset button on the inner side of the Network Camera. It is used to reboot the Network
Camera or restore the Network Camera to factory default. Sometimes rebooting the Network
Camera could set the Network Camera back to normal state. If the problems remain after
rebooted, restore the Network Camera to factory default and install again.
Reboot : Press and release the reset button with a needle. Wait for the Network Camera to
reboot.
Restore : Press the indented reset button continuously for over 30 seconds until the status LED
rapidly blinks red and green simultaneously. Note that all settings will be restored to factory
default.