Routing gateway configuration, Defining “route priors” logic – Vista Imaging Vista Routing User Manual
Page 51
Routing User Guide
Configuring Routing
3
Enter
2
to select “Gateway Configuration and DICOM Master Files.”
4
Enter
1
to select “Update Gateway Configuration files.”
5
Set the prompts indicated in bold below to Yes.
…
Will this computer be a DICOM Image Gateway? YES// YES
Will this computer be a DICOM Text Gateway? NO// NO
Will this computer be a Routing Gateway? NO// NO
Will this computer be part of a system where autorouting is active? NO// Yes
Â
Send text to a commercial PACS, Mitra Broker, et cetera? NO// NO
…
6
Press
<Enter>
to cycle though the rest of the prompts and to exit the program.
Routing Gateway Configuration
The workstation serving as a Routing Gateway will need to have its configuration file set
as described below. Completing these steps will make the Routing Gateway menu option
and its submenus available in the main DICOM Gateway Menu [
MAGDMENU
].
 The following steps cover only routing-related configuration parameters. For
information about other configuration parameters, refer to the DICOM Gateway
Installation Guide.
To configure the Routing Gateway
1
Open a terminal window and log into the DICOM Gateway software.
2
Enter
4
to select “System Maintenance” from the DICOM Gateway Menu.
3
Enter
2
to select “Gateway Configuration and DICOM Master Files.”
4
Enter
1
to select “Update Gateway Configuration files.”
5
Set the prompts indicated in bold below to Yes.
…
Will this computer be a DICOM Image Gateway? YES// NO
Will this computer be a DICOM Text Gateway? NO// NO
Will this computer be a Routing Gateway? NO// Yes
Â
Will this computer be part of a system where autorouting is active? NO// Yes
Â
Send text to a commercial PACS, Mitra Broker, et cetera? NO// NO
…
April 2006
VistA Imaging V. 3.0, Patch 18
43