Vertex Standard FT-2800M - Manual (Page 55)

53 FT-2800M O
PERATING
M
ANUAL
20 RF SQL
Function: Adjusts the RF Squelch threshold level.
Available Values: 1 - 10, or OFF
Default: OFF
21 RPTR
Function: Sets the Repeater Shift direction.
Available Values: –RPTR/+RPTR/SIMP
Default: SIMP
22 RVRT
Function: Enables/disables the “Priority Channel Revert” feature.
Available Values: ON/OFF
Default: OFF
23 SCAN
Function: Selects the Scan Resume mode.
Available Values: BUSY/HOLD/5 SEC
Default: BUSY
BUSY: The scanner will remain halted for as long as there is carrier present on the channel;
after the carrier drops at the end of the other station’s transmission, the scanner will
resume.
HOLD: The scanner will halt on a signal it encounters. It will not restart automatically; you
must manually re-initiate scanning if you wish to resume.
5 SEC: The scanner will halt for five seconds only, after which scanning will resume (whether
or not the other station is still transmission).
24 SHIFT
Function: Sets the magnitude of the Repeater Shift
Available Values: 00.00 - 99.95 (MHz) (only shifts of less than 4 MHz will work)
Default: 00.60 (MHz)
25 SKIP
Function: Selects the Memory Scan mode.
Available Values: SKIP/ONLY/OFF
Default: OFF
SKIP:
The scanner will “skip” the flagged channels during scanning.
ONLY: The scanner will only scan channels that are flagged (Preferential Scan List).
“S
ET
” (M
ENU
) M
ODE
M
ENU
S
ELECTION
D
ETAILS