VocoPro KJ-7000 Pro - Manual (Page 10)

10
Stereo Panel Descriptions and Functions
1. SOURCE INPUTS – These inputs are for
connecting your MUSIC SOURCES to the KJ-7000
Pro. You can have both an A/V source and a
turntable connected to each channel, however only
one can be selected at a time via the source toggle
switch (see below). Note: If you are connecting a
turntable, be sure to connect it to the jacks labeled
“phono”, as they have a lower signal output ratio and
are designed specifically for turntables.
2. SOURCE TOGGLE – This switch will toggle
between any sources connected to that channel. As
stated above, if you have both a CD+G player and a
turntable connected to the same channel, only that
device to which this SOURCE TOGGLE is selected
would be audible. Note: You can toggle sources “on
the fly” at any time.
3. GAIN - This knob controls the input level from that
channels selected source. To increase the GAIN,
turn clockwise. Note: Adjusting this knob is not
synonymous to adjusting the channel fader. The gain
knob adjusts the input level from the source, while
the channel fader adjusts the output level from the
source.
4. CHANNEL FADER - The fader raises and lowers
the music volume of the channel as it is moved up or
down.
5. CUE - This monitors the input signal from the mix
board to the headphones. Press CUE to hear that
channel through the headphones. Note: If you cue
more than one channel, those channels will be
audible as well.
6. KEY - This assigns DIGITAL KEY CONTROL to
the channel. If the button is pressed, DIGITAL KEY
CONTROL will be applied to that channel.
7. DIGITAL KEY CONTROL – This Controller allows
you to modify the original key of a track without
changing its tempo. The Controller can step up or
down for a total of 11-Steps. To step DOWN, press
the left button marked “b”. To step UP, press the right
button marked “#”. To revert back to the ORIGINAL
key press the middle key. Note: Key changes are
only cueable when Master cueing.
8. ASSIGN – These buttons work in conjunction with
the crossfader slide control. ASSIGN allows the user
to select the channels to be included in the “cross
fade”.
9. CROSSFADER – The CROSSFADER allows the
user to fade the music out from one source and in to
another source creating a “mix”. Note: The
crossfader will only fade in/out from the two sources
that have been assigned to it.
A/V1
A/V1
PHONO 1
PHONO 1
A/V1 A/V2 A/V3
b
DIGITAL KEY CONTROLLER
CROSSFADER
#
L
R
0
0
1 2 3 4 5 5 4 3 2 1 L L
10
10
8
CUE
KEY
6
4
2
0
1
ASSIGN
2 2
ASSIGN
3
10
8
CUE
KEY
6
4
2
0
10
8
CUE
KEY
6
4
2
0
A/V2
A/V2
PHONO 2
PHONO 2
L
R
0
0 10
A/V3
A/V3
CD
CD
L
R
0 10
1
2
3
4
5
6
7
8
9